Method
Climate data in energy calculations under NS 3031:2025
Climate decides how much heat a building needs and how much power its systems must deliver. NS 3031:2025 replaces the normalized Oslo climate with the local climate of each municipality, based on hourly values from the current 1991 to 2020 normal period.
From Oslo climate to local climate
Energy calculations against requirements used to be done in a normalized Oslo climate. NS 3031:2025 moves to local climate and introduces climate correction factors, so the result can still be compared with requirements that use Oslo as the reference. For energy labeling, the grade is calculated in the normalized climate, while the certificate also shows delivered energy in the local climate.
Typical years, hour by hour
The Norwegian Meteorological Institute (MET) and NMBU have created typical meteorological years with hourly values for every municipality in Norway, for use with NS 3031:2025. They are based on the CERRA reanalysis, on a 5.5 by 5.5 km grid, for the period 1991 to 2020. The method weights air temperature most heavily from October to March, when heating demand is highest. The data is openly published.
- Temperature, solar radiation, wind and humidity for every hour of a typical year
- One climate location per municipal center
- The basis for the climate correction factors in the standard
Design temperature and peak load
Design climate data for all municipalities was updated in collaboration with MET. The design outdoor temperature is used to calculate the peak load, which decides the size of heat pumps, boilers and grid connection. With local data, sizing is more accurate than with one shared reference climate.
A warmer climate means lower heating demand
Heating degree days for the 1991 to 2020 normal period are lower than for the older normal periods, as a result of a warmer climate, especially in winter. That means the same building can get a slightly lower calculated heating demand with new climate data than with old.
How Proff handles it
Climate data in Gadder Proff
Proff uses the typical years from the 1991 to 2020 normal period for every municipality, and takes the design outdoor temperature from NS 3031:2025.
- Hourly data for a typical year, chosen from the building's municipality
- Design outdoor temperature and design days from NS 3031:2025
- The option to upload your own climate file in EPW format
- The same climate data for energy, peak loads and overheating
Questions and answers
TEK17 section 14-2 still refers to NS 3031:2014 and a reference climate. The Norwegian Building Authority consulted on changes to the energy requirements in 2026.
Sources and regulations
Always check the current version of regulations and standards before using the numbers in a project.
Read next
NS 3031:2025 and energy performance calculation
The standard every Norwegian energy calculation is built on, and what is new in the 2025 edition.
Peak loads and overheating in buildings
Design heating and cooling loads, and hours with too high indoor temperature.
Energy simulation for buildings and homes
Dynamic simulation hour by hour and quarter hour by quarter hour: when it gives better answers and how the result is checked.
Spend your time on judgment, not data entry
Proff gathers available building data, reads floor plans and builds an editable model, so you can calculate everything from houses to hospitals without the detours.